C:\Projects\Arduino After extracting, the following files should exist. For example, if the Arduino Sketch folder is. #Program at90s2313 with arduino ide archiveC:\Projects\Arduino\hardware\ * Extract the contents of the archive into the "hardware" folder. C:\Projects\Arduino\ Ensure this folder exists. * Ensure the "hardware" folder exists under the Arduino Sketch folder. This is the folder where the Arduino IDE stores Sketches. #Program at90s2313 with arduino ide download* Download the Arduino-Tiny archive (ZIP-file). You can download the files here: This is what the instructions in the read me say: Ensure the Arduino IDE is NOT running. You could also use some electrical insulating gel/glue. #Program at90s2313 with arduino ide how toThen once everything has been wired up connect it to the arduino and upload a test code to make sure everything works fine (Instructions on how to do this on the next step), then once the testing is done you can add some hot-glue around the solder joints to make sure they are firm and don't make any sort of wrong connections. Then connect the right pins from the male header onto the female headers according to the pin-out (Female headers are going to be used to attach the ATtiny2313 and male headers are going to be used to attach the shield to the arduino) Then add the 2 LED's and the capacitor and connect them according to the pin-out as well, make sure the capacitor is attached the right way if its a polarized capacitor. Start off by attaching the female headers in the center of the protoboard and then put the male headers in the arduino and then put the protoboard on it so as to get the exact position where to solder the male headers. So now in this instructable I will show you how to build one of these shields for yourself! It costs almost nothing and takes only about 30mins or so to make it. After thinking for a bit, I decided to make a simple and easy to make, ATtiny2313 programming shield, after I made it, all I needed to do to recode any of my attinys' is to just put it in the programming shield and just in a few clicks you have your code uploaded! No need to worry if everything is wired right and make sure there are no short circuits or anything that can short out the chip and fry it or anything else of that sort. After spending about an hour I just realized I was wasting my time as there was no way I was going to spend about 20-30 dollars on a simple shield. So I went on to eBay and amazon searching for something to program these chips as I was planning on using these chips a lot in the future. Whenever I had to reprogram the LED cube when I thought of more awesome patterns, I had to get out my breadboard and then wire up everything again referring to pin-outs of ATtiny2313 and make sure everything is connected right and then finally upload the new code. Today, I made a small 3x3x3 LED cube with an ATtiny2313 that I had from about 2 weeks ago.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |